Ideas for Exterior Sliding Barn Door Kit
Exterior Sliding Barn Door Kit – An experienced woodworker with a fully equipped workshop can make doors and set them up as a slider. But the average do-it-yourself enthusiast often fined this type of project time consuming and difficult. You can convert a few doors to the controls or buy new doors at most home improvement stores. Obtain a pair of doors, based on the size of the door, and sliding door includes a kit with rollers, guides and the roller track.
Determine the length of the roller track by measuring the width of the door opening between the inner surfaces of the side pieces in each side. For Exterior Sliding Barn Door Kit, measure the width of the opening at floor level. Measure and mark the runway to length. Cut the groove with a hacksaw and remove any burrs on the cut end with a sanding block. Set up a power or screwdriver with a screw-top bracket. Place the groove on top of the opening or at the floor and directing the inner edge with the inner edges of the doorjambs at each side. Secure the track over the top of the opening or the floor by the screws at each of the processed holes in the track.
Doors and rolls
Place a plate on top of the doors of two trestles. Place the goats, as necessary, so that the door is stable. Attach both rolls on the upper edge of an inner door, or the lower edge of a front door with the help of the screws. Typically the rollers are two inches from the corresponding outer edges of the Exterior Sliding Barn Door Kit. Determine how much of the door must be cut off. Measure the distance from the center of the roll to the opposite end of the door at each edge of the door. Note this measurement. For a single door, measure the vertical distance from the center of the rolling passage of the web to the floor, and vice versa for a front door. The difference between the measurements is the amount that goes in the door.